There are 2 ways; which one depends on how many USB ports you have. If you have 2, then put both flash drives in, open up in the file browser and move the information between the two drives in the file browser. If there is only one socket, put the first flash drive in and place the files to be transferred on the computer, then unlpug and put the next drive in. If you have no USB ports, you will need an adapter (Mac). You could also transfer files to the Cloud, then download them onto the other flash drive.
Optical storage devices are among the cheapest methods of mass data storage after the hard drive. They are slower than their flash-based counterparts. Standard 120 mm optical discs are larger than flash drives and more subject to damage. Smaller optical media do exist, such as business card CD-Rs which have the same dimensions as a credit card, and the slightly less convenient but higher capacity 80 mm recordable MiniCD and Mini DVD. The small discs are more expensive than the standard size, and do not work in all drives.
This USB 3.0 drive offers what the company is calling business-grade security with 256-bit AES hardware-based encryption. You can also choose a stepped up “managed” version that offers a more complete set of management tools using SafeConsole as support. Finally, there’s an anti-virus version that loads in ESET antivirus software out of the box to avoid trojan horses and other hacker tracking programs. All of the models are TAA-compliant, so this drive won’t be in breach of government regulations, and that USB 3.0 means that you’ll have nearly the fastest transfer speeds possible. You can pick it up in sizes ranging from 4GB to 64GB.
Flash drives are often measured by the rate at which they transfer data. Transfer rates may be given in megabytes per second (MB/s), megabits per second (Mbit/s), or in optical drive multipliers such as "180X" (180 times 150 KiB/s).[19] File transfer rates vary considerably among devices. Second generation flash drives have claimed to read at up to 30 MB/s and write at about half that rate, which was about 20 times faster than the theoretical transfer rate achievable by the previous model, USB 1.1, which is limited to 12 Mbit/s (1.5 MB/s) with accounted overhead.[20] The effective transfer rate of a device is significantly affected by the data access pattern.[21]
Flash memory combines a number of older technologies, with lower cost, lower power consumption and small size made possible by advances in microprocessor technology. The memory storage was based on earlier EPROM and EEPROM technologies. These had limited capacity, were slow for both reading and writing, required complex high-voltage drive circuitry, and could be re-written only after erasing the entire contents of the chip.
Most USB-based flash technology integrates a printed circuit board with a metal tip, which is simply soldered on. As a result, the stress point is where the two pieces join. The quality control of some manufacturers does not ensure a proper solder temperature, further weakening the stress point.[77][78] Since many flash drives stick out from computers, they are likely to be bumped repeatedly and may break at the stress point. Most of the time, a break at the stress point tears the joint from the printed circuit board and results in permanent damage. However, some manufacturers produce discreet flash drives that do not stick out, and others use a solid metal uni-body that has no easily discernible stress point. SD cards serve as a good alternative to USB drives since they can be inserted flush.
There are 2 ways; which one depends on how many USB ports you have. If you have 2, then put both flash drives in, open up in the file browser and move the information between the two drives in the file browser. If there is only one socket, put the first flash drive in and place the files to be transferred on the computer, then unlpug and put the next drive in. If you have no USB ports, you will need an adapter (Mac). You could also transfer files to the Cloud, then download them onto the other flash drive.
