Also, HP has introduced a USB floppy drive key, which is an ordinary USB flash drive with additional possilibility for performing floppy drive emulation, allowing its usage for updating system firmware where direct usage of USB flash drives is not supported. Desired mode of operation (either regular USB mass storage device or of floppy drive emulation) is made selectable by a sliding switch on the device's housing.[51][52]
Some file systems are designed to distribute usage over an entire memory device without concentrating usage on any part (e.g., for a directory) to prolong the life of simple flash memory devices. Some USB flash drives have this 'wear leveling' feature built into the software controller to prolong device life, while others do not, so it is not necessarily helpful to install one of these file systems.[39]
Most USB flash drives weigh less than 30 g (1 oz).[31] While some manufacturers are competing for the smallest size[32] with the biggest memory,[33] some manufacturers differentiate their products by using elaborate housings, which are often bulky and make the drive difficult to connect to the USB port. Because the USB port connectors on a computer housing are often closely spaced, plugging a flash drive into a USB port may block an adjacent port. Such devices may carry the USB logo only if sold with a separate extension cable. Such cables are USB-compatible but do not conform to the USB standard.[34][35]
In a typical well-conducted review of a number of high-performance USB 3.0 drives, a drive that could read large files at 68 MB/s and write at 46 MB/s, could only manage 14 MB/s and 0.3 MB/s with many small files. When combining streaming reads and writes the speed of another drive, that could read at 92 MB/s and write at 70 MB/s, was 8 MB/s. These differences differ radically from one drive to another; some drives could write small files at over 10% of the speed for large ones. The examples given are chosen to illustrate extremes....′[46]
Most USB-based flash technology integrates a printed circuit board with a metal tip, which is simply soldered on. As a result, the stress point is where the two pieces join. The quality control of some manufacturers does not ensure a proper solder temperature, further weakening the stress point.[77][78] Since many flash drives stick out from computers, they are likely to be bumped repeatedly and may break at the stress point. Most of the time, a break at the stress point tears the joint from the printed circuit board and results in permanent damage. However, some manufacturers produce discreet flash drives that do not stick out, and others use a solid metal uni-body that has no easily discernible stress point. SD cards serve as a good alternative to USB drives since they can be inserted flush.
You can get USB 3.0 speed in a compact and durable metal USB drive from Kingston for under $10. It sports a capless design with a sturdy keyring, perfect for travel or as a part of your everyday carry. The design can even be customized to add your logo or company name. Read speeds top 100 Mb/s, while write speeds are on the slow end. With a five-year warranty, a great design, and a value price, this small drive makes a perfect addition to your keyring.
USB 2.0 flash drives have a transfer rate of up to 480Mbps, while USB 3.0 flash drives allow for transfer rates 10 times faster — up to 4.8Gbps. However, you can only take advantage of this higher speed if your device has a USB 3.0 port. Although USB 3.0 flash drives and other devices are backwards compatible with USB 2.0 ports, they will only operate at a USB 2.0 rate.
