A minority of flash drives support biometric fingerprinting to confirm the user's identity. As of mid-2005,[needs update] this was an expensive alternative to standard password protection offered on many new USB flash storage devices. Most fingerprint scanning drives rely upon the host operating system to validate the fingerprint via a software driver, often restricting the drive to Microsoft Windows computers. However, there are USB drives with fingerprint scanners which use controllers that allow access to protected data without any authentication.[70]
Unlike solid-state memory, hard drives are susceptible to damage by shock (e.g., a short fall) and vibration, have limitations on use at high altitude, and although they are shielded by their casings, they are vulnerable when exposed to strong magnetic fields. In terms of overall mass, hard drives are usually larger and heavier than flash drives; however, hard disks sometimes weigh less per unit of storage. Like flash drives, hard disks also suffer from file fragmentation, which can reduce access speed.
Also, HP has introduced a USB floppy drive key, which is an ordinary USB flash drive with additional possilibility for performing floppy drive emulation, allowing its usage for updating system firmware where direct usage of USB flash drives is not supported. Desired mode of operation (either regular USB mass storage device or of floppy drive emulation) is made selectable by a sliding switch on the device's housing.[51][52]
Flash memory cards, e.g., Secure Digital cards, are available in various formats and capacities, and are used by many consumer devices. However, while virtually all PCs have USB ports, allowing the use of USB flash drives, memory card readers are not commonly supplied as standard equipment (particularly with desktop computers). Although inexpensive card readers are available that read many common formats, this results in two pieces of portable equipment (card plus reader) rather than one.
Some file systems are designed to distribute usage over an entire memory device without concentrating usage on any part (e.g., for a directory) to prolong the life of simple flash memory devices. Some USB flash drives have this 'wear leveling' feature built into the software controller to prolong device life, while others do not, so it is not necessarily helpful to install one of these file systems.[39]
Anyone who has accidentally left their flash drive in their pants pockets through a laundry cycle will appreciate the durability of this Samsung drive. Its durable metal casing is waterproof, shockproof, magnetproof, and resistant to high temperatures. The drive is housed inside the metal casing, so it won’t break off (and the keyring is made with the same quality casing, again helping your drive live longer). Samsung believes in this drive enough to provide a five-year warranty should anything happen. Durability isn’t its only perk, either. USB 3.0 and NAND technology gives this drive data transfer respectable read speeds of up to 130 MB/s and write speeds over 100 MB/s. It is also backwards compatible with USB 2.0, but expect a drop in transfer speeds.
Specially manufactured flash drives are available that have a tough rubber or metal casing designed to be waterproof and virtually "unbreakable". These flash drives retain their memory after being submerged in water, and even through a machine wash. Leaving such a flash drive out to dry completely before allowing current to run through it has been known to result in a working drive with no future problems. Channel Five's Gadget Show cooked one of these flash drives with propane, froze it with dry ice, submerged it in various acidic liquids, ran over it with a jeep and fired it against a wall with a mortar. A company specializing in recovering lost data from computer drives managed to recover all the data on the drive.[64] All data on the other removable storage devices tested, using optical or magnetic technologies, were destroyed.
As of 2011, newer flash memory designs have much higher estimated lifetimes. Several manufacturers are now offering warranties of 5 years or more. Such warranties should make the device more attractive for more applications. By reducing the probability of the device's premature failure, flash memory devices can now be considered for use where a magnetic disk would normally have been required. Flash drives have also experienced an exponential growth in their storage capacity over time (following the Moore's Law growth curve). As of 2013, single-packaged devices with capacities of 1 TB are readily available,[54] and devices with 16 GB capacity are very economical. Storage capacities in this range have traditionally been considered to offer adequate space, because they allow enough space for both the operating system software and some free space for the user's data.
Flash drives are also cost-effective. You can securely store a few dozen gigabytes of data for less than $30, and these devices range in storage capacity, price and overall size - equal to the amount you're willing to invest. Some even have special features like lanyards, locks, belt clips and key fobs to make them easier to carry and keep track of.
Some value-added resellers are now using a flash drive as part of small-business turnkey solutions (e.g., point-of-sale systems). The drive is used as a backup medium: at the close of business each night, the drive is inserted, and a database backup is saved to the drive. Alternatively, the drive can be left inserted through the business day, and data regularly updated. In either case, the drive is removed at night and taken offsite.
Hardware designers later developed EEPROMs with the erasure region broken up into smaller "fields" that could be erased individually without affecting the others. Altering the contents of a particular memory location involved copying the entire field into an off-chip buffer memory, erasing the field, modifying the data as required in the buffer, and re-writing it into the same field. This required considerable computer support, and PC-based EEPROM flash memory systems often carried their own dedicated microprocessor system. Flash drives are more or less a miniaturized version of this.
Its a "branded" flash drive, so all our flash drives have imprint areas or laser etching that will make your logo pop! Whatever your event or program, there is likely a style of USB flash drive with an imprint area that provides just the right surface to make our images stand out. From 1 - 4 color spot to full-color process (try this on the credit card style drives!) your imprint will look fantastic.
Some manufacturers, aiming at a "best of both worlds" solution, have produced card readers that approach the size and form of USB flash drives (e.g., Kingston MobileLite,[65] SanDisk MobileMate[66]) These readers are limited to a specific subset of memory card formats (such as SD, microSD, or Memory Stick), and often completely enclose the card, offering durability and portability approaching, if not quite equal to, that of a flash drive. Although the combined cost of a mini-reader and a memory card is usually slightly higher than a USB flash drive of comparable capacity, the reader + card solution offers additional flexibility of use, and virtually "unlimited" capacity. The ubiquity of SD cards is such that, circa 2011, due to economies of scale, their price is now less than an equivalent-capacity USB flash drive, even with the added cost of a USB SD card reader.
Modern devices are thinner and lighter, and the Type-C connector is a plug format designed to work with these products. In addition to being smaller than a standard USB plug, Type-C connectors are reversible, so they're easier to use. Some USB flash drives include both a traditional plug and a Type-C connector. These products are ideal for transferring files between computers and portable devices such as smartphones or tablets.
